EL304X中文资料
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Features:
? Peak breakdown voltage - 250V: EL303X
- 400V: EL304X - 600V: EL306X - 800V: EL308X
? High isolation voltage between input and output (Viso=5000 V rms ) ?
Zero voltage crossing
? Pb free and RoHS compliant. ? UL approved (No.E214129) ? VDE approval (pending) ? SEMKO approval (pending) ? NEMKO approval (pending) ? DEMKO approval (pending) ? FIMKO approval (pending) ? CSA approval (pending)
Description
The EL303X, EL304X, EL306X and EL308X series of devices each consist of a GaAs infrared emitting diode optically coupled to a monolithic silicon zero voltage crossing photo triac.
They are designed for use with a discrete power triac in the interface of logic systems to equipment powered from 110 to 380 VAC lines, Schematic
such as solid-state relays, industrial controls, motors, solenoids and consumer appliances.
Applications
z Solenoid/valve controls z Light controls
z Static power switch z AC motor drivers z E.M. contactors
z Temperature controls z AC Motor starters
Pin Configuration 1. Anode 2. Cathode
3. No Connection
4. Terminal
5. Substrate
(do not connect) 6. Terminal
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Absolute Maximum Ratings (T a =25°C)
Parameter Symbol Rating Unit Forward current
I F 60 mA Reverse voltage V R 6 V 100 mW Input
Power dissipation
Derating factor (above 85°C)
P D
3.8 mW /°C
EL303X
250 EL304X 400 EL306X 600 Off-state Output Terminal Voltage
EL308X
V DRM 800
V Peak Repetitive Surge Current I TSM 1 A 300 mW Output
Power dissipation
Derating factor (above 85°C)
P D 7.6
mW /°C Isolation voltage *1 V iso
5000 V rms
Total power dissipation P D 330 mW Operating temperature T opr -55~+100 °C Storage temperature T stg -55~+125 °C Soldering temperature *2 T sol
260 °C
Notes
*1 AC for 1 minute, R.H.= 40 ~ 60% R.H. In this test, pins 1, 2 & 3 are shorted together, and pins 4, 5 & 6 are shorted together. *2 For 10 seconds.
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Electrical Characteristics (T a =25°C unless specified otherwise)
Input
Parameter Symbol Min. Typ.* Max. Unit Condition
Forward voltage
V F - - 1.5 V I F = 30mA Reverse Leakage current
I R
- - 10 μA V R = 6V
Output
Parameter Symbol Min. Typ.* Max. Unit Condition
EL303X/304X 100
Peak
Blocking Current
EL306X/308X I DRM1
- - 500
nA V DRM = Rated V DRM
I F = 0mA
Peak On-state Voltage
V TM - - 3 V
I TM =100mA peak, I F =Rated
I FT
EL303X/304X 1000 - Critical
Rate of Rise of off-state Voltage
EL306X/308X dv/dt 600
V/μs V PEAK =Rated V DRM , I F =0
(Fig. 10)
Inhibit Voltage (MT1-MT2
voltage above which device will not trigger)
V INH - - 20 V
I F = Rated I FT Leakage in lnhibited State
I DRM2 - - 500 μA
I F = Rated I FT ,
V DRM =Rated V DRM , off state
Transfer Characteristics
Parameter Symbol Min. Typ.* Max. Unit Condition
EL3031
EL3041 EL3061 EL3081 - - 15
EL3032 EL3042 EL3062 EL3082 - - 10 LED Trigger Current
EL3033 EL3043 EL3063 EL3083
I FT
- - 5
mA
Main terminal Voltage=3V
Holding Current
I H
- 280 - μA
* Typical values at T a = 25°C
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Typical Performance Curves
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Figure 10. Static dv/dt Test Circuit & Waveform
Measurement Method
The high voltage pulse is set to the required V PEAK value and applied to the D.U.T. output side through the RC circuit above. LED current is not applied. The waveform V T is monitored using a x100 scope probe. By varying R TEST , the dv/dt (slope) is increased, until the D.U.T. is observed to trigger (waveform collapses). The dv/dt is then decreased until the D.U.T. stops triggering. At this point, τRC is recorded and the dv/dt calculated.
For example, V PEAK
V PEAK
Applied V T Waveform
dv/dt =
High Voltage Pulse Source
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER EL306X Series EL308X Series
Order Information
Part Number
EL303XY(Z)-V
or EL304XY(Z)-V
or EL306XY(Z)-V
or EL308XY(Z)-V
Note
X = Part No. (1, 2 or 3)
Y = Lead form option (S, S1, M or none)
Z = Tape and reel option (TA, TB or none).
V = VDE safety approved option
Option Description Packing
quantity None Standard DIP-6 65 units per tube
M Wide lead bend (0.4 inch spacing) 65 units per tube
S (TA) Surface mount lead form + TA tape & reel option 1000 units per reel
S (TB) Surface mount lead form + TB tape & reel option 1000 units per reel
S1 (TA) Surface mount lead form (low profile) + TA tape & reel option 1000 units per reel
S1 (TB) Surface mount lead form (low profile) + TB tape & reel option 1000 units per reel
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Package Drawings
(Dimensions in mm)
Standard DIP Type
Option M Type
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Option S Type
Option S1 Type
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER EL306X Series EL308X Series
Recommended pad layout for surface mount leadform
Device Marking
3083
YWWV
EL
Notes
EL denotes Everlight
3083 denotes Device Number
Y denotes 1 digit Year code
WW denotes 2 digit Week code
V denotes VDE option
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER
EL306X Series EL308X Series
Tape & Reel Packing Specifications
Tape dimensions
Dimension No. A B Do D1 E F Dimension (mm)
10.4±0.1 7.52±0.1 1.5+0.1/-0
1.5+0.1/-0 1.75±0.1 7.5±0.1
Dimension No. Po P1 P2 t
W K
Dimension (mm)
4.0±0.15 1.6±0.1 2.0±0.1 0.35±0.03 16.0±0.2 4.5±0.1
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER EL306X Series EL308X Series
Solder Reflow Temperature Profile
TIME (S)
6 PIN DIP ZERO CROSS TRIAC DRIVER PHOTOCOUPLER EL306X Series EL308X Series
DISCLAIMER
1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change
for above specification.
2. When using this product, please observe the absolute maximum ratings and the instructions for use
outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets.
3. These specification sheets include materials protected under copyright of EVERLIGHT. Reproduction in
any from is prohibited without the specific consent of EVERLIGHT.