NOTES:
1. All dimensions are in millimeters (inches);
2. Tolerances are ±0.1mm (0.004inch) unless otherwise noted.
Soldering iron
Basic spec is U 5sec when 260℃. If temperature is higher, time should be shorter (+10℃? -1sec ).Power dissipation of iron should be smaller than 15W, and temperatures should be controllable .Surface temperature of the device should be under 230℃ .
ITEM MATERIALS
Resin (mold) Epoxy Lens color Water Clear
Printed circuit board BT Dice InGaN
Emitted color
Super Blue
For Reflow Soldering For upright mounting
For right anoge mounting
Right Angle Lens Super Blue SMD Chip LED Lamps Part Number: AL-HB334A Package outlines & Re-flow Profile
Reflow Temp/Time
Part Number: AL-HB334A
ELECTRO-OPTICAL CHARACTERISTICS (T A=25℃)
Parameter Test
Condition Symbol Value Unit
Viewing angle at 50% I V I F
=10mA 2θ1/2 100 Deg
(Typ.) Forward voltage
(Max.)
I F
=20mA V F
2.80
3.20
V
(Min.) Luminous intensity
(Typ.)
I F
=20mA I V
30.0
50.0
mcd
Wavelength I F=20mA λp
λd
470
465±5
nm
Spectral Line Half-Width I F=20mA △λ30 nm
Peak pulsing current (1/10 duty f=1kHz) I FP 100 mA Absolute maximum ratings (T A=25℃)
Parameter Symbol
Value
Unit Forward current I F 30 mA Reverse voltage V R 5 V Reverse current I R 100 μA
Power Dissipation P D100 mW
Operating temperature range Top -25
~+80 ℃
Storage temperature range Tstg -30 ~+85 ℃
Lead soldering temperature 260℃For 5 Seconds
Part Number: AL-HB334A
Test items and results of reliability
*Refer to reliability test standard specification for in this line.
Part Number: AL-HB334A
Typical Optical-Electrical Characteristic Curves
Part Number: AL-HB334A
Typical Optical-Electrical Characteristic Curves