1. Test diagram 测试图示
2. Test result 测试结果
DC 300V/0.01s CR ≦3Ω IR ≧10MΩCable pulled away dimention 脱离尺寸
Visual Inspection 外观检验
Test result description 结果描述
Judgement 判定
5PCS
/
2014-9-22
Standard fixture of loading test machine DJS-EN61标准吊重测试设备 DJS-EN61Test environment
测试环境
Drawing NO.
工程图号HDMI M/M Ni Plated 30AWG OD:5.0 L=1.5/2.0M Black
/Sample Q'ty 样品数量
Part/No.产品料号Test machine 测试设备温度:28℃/湿度:75%
SHENZHEN EAST-TOPTECH ELECTRONIC TECHNOLOGY CO.,LTD
深圳市东景盛电子技术有限公司Loading Durability Test Report
吊 重 测 试 报 告Product name
产品名称
Product spec.
产品规格
HDMI AM TO AM 30AWG 1.4REV. OD :5.0mm Length :1.5/2.0M
Customer 客户名称/
Test date 测试日期
Test mothod 1(Front face)正面
Test mothod 2(Side face) 侧面
OK Sample No. 样品编号
Test Item 测试项目
Loading durability test of outer mold 外模吊重耐久测试
Result of measurement 测 试 结 果
Test Requirement 测 试 要 求
1. Fixed wire or outer mold to the center position of clamp, load 5Kgf weights in the wire 70CM line,duration of load 1min ,after test, do a conduction test. DC :300V/10ms, Insulation resistance 10MOHM MΩ ,Conduction need less than 3Ω;
将线材或外模固定于夹具中心位置,于线材70CM 处系5Kgf 砝码,保持1分钟,完成后进行导通测试,DC :300V/10ms,绝缘阻抗10 M Ω,导通小于3Ω;
2.The cable pulled away from the end position of the outer mold SR less than 2mm; Appearance: No damage;线材从外模SR 处脱出小于2mm,整体外观无损坏;
3.After test, no appearance defects; 测试后,外观良好;
OK Match condition 符合条件
No appearance defects 外观良好
OK 正面 < 2mm 1#Match condition 符合条件正面 < 2mm 侧面 < 2mm 2#3#Match condition 符合条件Match condition 符合条件■ PASS 合格 □ NG 不合格
Note 备注
According to ANSI/EIA-364-23Judgement 综合判定
4#5#No appearance defects 外观良好No appearance defects 外观良好No appearance defects 外观良好Match condition 符合条件No appearance defects 外观良好侧面 < 2mm 正面 < 2mm 正面 < 2mm 正面 < 2mm
侧面 < 2mm
OK OK OK
侧面 < 2mm 侧面 < 2mm 荷重
Weight 夾具
Fixing portion
Fixing portion 夾具
70C M
荷重
Weight 夾具
Fixing portion
Fixing portion 夾具
70C M
表单编号:DJS-QR-045