Available on Tape and Reel for Pick and Place Manufacturing.
USA/Canada: Toll Free: Europe :
(315) 432-8909 (800) 411-6596
+44 2392-232392
Ultra Low Profile 0805 Power Divider
50? to 50?
Description
The PD1722J5050S2 is a low profile, sub-miniature Wilkinson power divider in an easy to use surface mount package. The PD1722J5050S2 is ideal for high volume manufacturing and delivers higher performances than traditional printed and lumped element solutions. The PD1722J5050S2 is matched to 50 ? and has a height profile of 0.5 mm which is ideal for high level integrations in the following markets: WCDMA, and GSM, The PD1722J5050S2 does not include the resistive element and therefore, requires an external resistor for operation. The PD1722J5050S2 is available on tape and reel for high volume manufacturing pick and place.
Detailed Electrical Specifications: Specifications subject to change without notice.
ROOM (25°C) Parameter Min. Typ. Max
Unit Frequency
1700 2200 MHz Input Port Impedance 50 ? Output Port Impedance 50 ? Return Loss 10 13 dB Insertion Loss* 0.6 0.8
dB
Amplitude Balance
0.1 0.3 dB Phase Balance
1 3 Degrees Isolation (Output Ports) 15 18 dB Power Handling
2 Watts Features: ? 1700-2200 MHz
? 15 dB Isolation (output ports) ? 0.5mm Height Profile ? 50? Input / 50? Outputs ? Low Insertion Loss ? Surface Mountable ? Tape & Reel
? Non-conductive Surface ? RoHS Compliant
?
External resistor required
Operating Temperature -55 +85
oC
* Insertion Loss stated at room temperature (Insertion Loss is approximately 0.1 dB higher at +85 oC)
USA/Canada: Toll Free:
Europe:
(315) 432-8909
(800) 411-6596
+44 2392-232392
Available on Tape and
Reel for Pick and Place
Manufacturing.
Available on Tape and Reel for Pick and Place Manufacturing.
USA/Canada: Toll Free: Europe :
(315) 432-8909 (800) 411-6596 +44 2392-232392
USA/Canada: Toll Free:
Europe:
(315) 432-8909
(800) 411-6596
+44 2392-232392
Available on Tape and
Reel for Pick and Place
Manufacturing.
Mounting Configuration:
In order for Xinger surface mount components to work optimally, the proper impedance transmission lines must be used to connect to the RF ports. If this condition is not satisfied, insertion loss, Isolation and VSWR may not meet published specifications.
An example of the PCB footprint used in the testing of these parts is shown below. In specific designs, the transmission line widths need to be adjusted to the unique dielectric coefficients and thicknesses as well as varying pick and place equipment tolerances. In addition, since the PD1722J5050S2 is a Wilkinson power divider, an external 0603 100? resistor must be mounted in locations R1 as shown in the Figure below.
Available on Tape and Reel for Pick and Place Manufacturing.
USA/Canada: Toll Free: Europe :
(315) 432-8909 (800) 411-6596 +44 2392-232392
Packaging and Ordering Information